Competency Course for Replacement of 240 volts Single Phase Electrical Plugs and Sockets.

NSW WorkCover's guide to Testing and Tagging of Electrical equipment states "Plugs and extension sockets may be replaced by a non-electrically qualified person provided the person has been trained, assessed and found to be competent to fit plugs and sockets according to the manufacture's instructions."

It is a prerequisite of this training course that all candidates have attended a recognised course in the inspection and testing of electrical equipment to AS/NZS3760 and have been assessed and found to be competent. No exceptions.

Approved by the NSW Office of Fair Trading to earn 3 CPD points.

The purpose of this course is to allow those who have successfully completed an electrical testing and tagging course to acquire the knowledge and skills required to replace plugs and extension sockets to portable electrical equipment. 

The duration of the course is approximately  3 hours including an assessment. During the course you will be required to construct a single phase extension lead. 

All tools, materials and instruction manual supplied. 

__________________________________

PARRAMATTA

PLUG REPLACEMENT

OCTOBER AM COURSE

• Date Wed 3rd October 2012 COURSE FULL

• 8.30am  to 11.30am 

• Cost - $198 incl GST

• Venue - Parramatta Workers Club

PARRAMATTA

PLUG REPLACEMENT

OCTOBER PM COURSE

• Date Wed 3rd October 2012 

• 1.00pm  to 4.00pm 

• Cost - $198 incl GST

• Venue - Parramatta Workers Club

__________________________________